Calibre UK UCA93 Manuel d'utilisateur

 Calibre UK Ltd 1999 CALIBRE I2C for Windows USB Manual WINI2CUCA93 Issue 1.0 18/18/03

CALIBRE Issue 1.0 Page 7 18/18/03 1.11.2. Should a master function report that the slave is not responding the most probable causes are:- 1. The

CALIBRE Issue 1.0 Page 8 18/18/03 1.14. Changing Files Manually 1.14.1. All files saved using the Save command, can be edited manually by loading

CALIBRE Issue 1.0 Page 9 18/18/03 THE MOST COMMONLY ASKED I2C QUESTIONS General Questions Question Will my adapter run I2C clock speeds greater t

CALIBRE Issue 1.0 Page i 18/18/03 Welcome to the Calibre I2C for Windows application. This application is designed to allow non-specialist users

CALIBRE Issue 1.0 Page ii 18/18/03 CONTENTS I2C FOR WINDOWS MANUAL...

CALIBRE Issue 1.0 Page 1 18/18/03 I2C FOR WINDOWS MANUAL 1.1. System requirements 1.1.1. The software requires a PC with a 900MHz Duron, Athlon, C

CALIBRE Issue 1.0 Page 2 18/18/03 1.4.4. Configuration Controls 1.4.4.1. Clicking the OK button will configure the card with the values specified.

CALIBRE Issue 1.0 Page 3 18/18/03 1.7. Function menu commands 1.7.1. Master Read 1.7.1.1. Sets up the software to run as a MASTER (the adapter lo

CALIBRE Issue 1.0 Page 4 18/18/03 1.7.4.2. This function writes the given data to the entire memory, if the memory consists of more than one page

CALIBRE Issue 1.0 Page 5 18/18/03 1.7.6.7. This allows the master to write data to anywhere within the data table and as such the Slave Receiver c

CALIBRE Issue 1.0 Page 6 18/18/03 1.9.1.2. An own address of 0 ("general call address") MUST NOT be used as the adapter will go into mon