Calibre UK Ltd 1999CALIBREI2C for Windows 95 ManualWINI2C/I95Issue 2.416/07/1999
CALIBREIssue 2.4Page 716/07/991.9.1.2. An own address of 0 ("general call address") MUST NOT be used as the adapter will go intomonitor mode
CALIBREIssue 2.4Page 816/07/991. Check the link configuration of the adapter and also the addresses of other cardswithin your system then re-start the
CALIBREIssue 2.4Page 916/07/994. Confirm the comment is to be deleted.1.13.4. To view the data again move the horizontal scroll bar to the left.1.13.5
CALIBREIssue 2.4Page 1016/07/99THE MOST COMMONLY ASKED I2C QUESTIONS2.1. General QuestionsQuestion Will my adapter work in a Pentium PC?Answer Yes and
CALIBREIssue 2.4Page 1116/07/992.3. WINDOWS 95 and NT QuestionsQuestion My software cannot find the adapter. Your Windows software reports that itcan
CALIBREIssue 2.4Page 1216/07/99Send us the following details:-1)The link settings of the adapter.2)A sketch of the relevant I2C hardware including the
CALIBREIssue 2.4 Calibre UK Ltd 1999 Page iWelcome to the Calibre I2C for Windows 95 application. This application is designed to allow non-specialis
CALIBREIssue 2.4 Calibre UK Ltd 1999 Page iiCONTENTSI2C FOR WINDOWS 95 MANUAL ...
CALIBREIssue 2.4Page 116/07/99I2C FOR WINDOWS 95 MANUAL1.1. System requirements1.1.1. The software requires a PC with a 386 or better processor, Windo
CALIBREIssue 2.4Page 216/07/991.3.4. The Real-Time Bus Monitor cannot be activated from the Windows 95 version, it isrecommended that you run the REAL
CALIBREIssue 2.4Page 316/07/991.5.2.2. The parameters displayed in the transfer parameter frame are those relevant to the functionselected (see Functi
CALIBREIssue 2.4Page 416/07/991.7.1.2. If the Slave does not require an offset as part of the protocol (See the component datasheet for details) click
CALIBREIssue 2.4Page 516/07/991.7.4.3. To start the transfer click on Write.1.7.5. Slave Sender1.7.5.1. Sets up the software as SLAVE (the adapter loc
CALIBREIssue 2.4Page 616/07/991.7.6.8. Protocol 2 (as seen from the Master)Slave Write AddressWrite DataStop1.7.6.9. The data received using this prot
Commentaires sur ces manuels